2004 Bombardier Quest/Traxter Series Shop Manual, Page 200Get this manual
Section 03 ENGINE QUEST Subsection 11 (CVT)
CAUTION: To avoid damage, make sure cleaner does not contact the countershaft seal
BUSHINGS BORE DIAMETER MINIMUM (new) MAXIMUM (new) SERVICE LIMIT 30.060 mm (1.183 in) 30.100 mm (1.185 in) 30.200 mm (1.189 in)
R610tran19A
1Main shaft support
Inspection
Sliding Half Check bushings no29 for cracks, scratch and for free movement when assembled to sliding halfUsing dial bore gauge measure bushing diameterMeasuring point must be at least mm (14 in) from bushing edgeThis bushing can not be replacedReplace sliding half if bushings no29 are out of specificationVisually inspect coatings1
Fixed Half Check ball bearing for free play and smooth operationReplace if necessaryCheck shaft for heavy wear or visible damageReplace if necessaryIf the shaft is removed, using dial bore gauge, measure bushing diameterMeasuring point must be at least mm (14 in) from bushing edgeThis bushing can not be replacedReplace fixed half if bushing no30 is out of specificationVisually inspect coatingsBUSHING BORE DIAMETER MINIMUM (new) MAXIMUM (new) SERVICE LIMIT 30.060 mm (1.183 in) 30.100 mm (1.185 in) 30.200 mm (1.189 in)