2004 Bombardier Quest/Traxter Series Shop Manual, Page 156Get this manual
Section 03 ENGINE QUEST Subsection 09 (CRANKSHAFTBALANCER SHAFT)
Plain Bearing Removal Procedure
CAUTION: Always support crankcase housings properly when ball bearings, needle bearings or plain bearings are removedCrankcase housing damages may occur if this procedure is not performed correctlyNOTE: Always use press for removal or installation of plain bearing halvesRemove plain bearings no11, no12, no13 and no14 with the proper plain bearing removerNOTE: Place the proper crankcase support under crankcase before removing plain bearingsPLAIN BEARING REMOVER MAG side PTO side 529 035 753 529 035 752
R610motr221A
MAG plain bearing without groove Oil bore Split of the plain bearing halves Cylinder base direction Plain bearing inside diameter to be measured in area of oil bore