2004 Bombardier Quest/Traxter Series Shop Manual, Page 126Get this manual
Section 03 ENGINE QUEST Subsection 08 (CYLINDER AND CYLINDER HEAD)
Inspection
Check spark plug and ignition coil condition (refer to IGNITION SYSTEM)NOTE: To check spark, place connected spark plug with threads against crankcase to simulate electrical ground and crank the engine
valve cover no5 and profile sealing ring no6
Installation
For installation, reverse the removal procedurePay attention to the following detailsCheck spark plug gap (refer to TECHNICAL DATA)Place spark plug into ignition coil, screw spark plug then remove the ignition coilTorque spark plug to 20 Nm (15 lbfft)Reinstall the ignition coil
THERMOSTAT
Refer to COOLING SYSTEM
R610motr89A
1Valve cover 2Profile sealing ring