2004 Bombardier Quest/Traxter Series Shop Manual, Page 118Get this manual
Section 03 ENGINE QUEST Subsection 07 (LUBRICATION SYSTEM)
Installation
For installation, reverse the removal procedureReinstall oil strainer with sealing edge towards engine
Start engine and let idle for few minutesEnsure oil filter and magnetic drain plug areas are not leakingStop engineWait while to allow oil to flow down to crankcase then check oil levelRefill as necessary
ENGINE OIL PRESSURE REGULATOR
The oil pressure regulator is located on the engine MAG side (behind magneto housing cover)R610motr266A
1Sealing edge 2Direction of reinstallation
Torque oil strainer cover screws as per following sequence1 5