2004 Bombardier Quest/Traxter Series Shop Manual, Page 89Get this manual
Section 03 ENGINE QUEST Subsection 04 (REMOVAL AND INSTALLATION)
From bottom side, do the following: Install front and rear propeller shaft boltsReinstall the eight (8) engine bracket bolts from the four(4) lower engine bracketsTighten the two (2) lower engine mount boltsReinstall upper engine-mount assembly but do not tighten the three (3) top nuts at this timeThis will be done when the seat bracket is installedFrom the top side, install the following: carburetor breather and its hose upper coolant hose ignition coil and connect itOn left side of vehicle, install the following: CVT breather box magneto, gear box and speed sensor connectors fuel valve bracket and reconnect hose from fuel valve to fuel pump drive and driven pulleys CVT cover LH footrest LH engine side panelOn right side of vehicle, do the following: Connect: large CVT outlet hose lower coolant hose to engine oil pressure sensor water temperature sensor wires to starterInstall: exhaust pipe and mounting bolts exhaust springs exhaust shield seat support bracket plastic transmission lever locator (do not tighten at this time) transmission lever NOTE: Place the transmission lever in NEUTRAL position and place the plastic transmission lever locator so that the notch is in the center of the transmission lever handle holder