2004 Bombardier Outlander 330/400 Factory Service Manual, Page 285Get this manual
Section 07 STEERING Subsection 02 (STEERING SYSTEM) NOTE: Install new cotter pinBoth ends of cotter pin must be folded
TOE ADJUSTMENT
Place vehicle on level surfaceCheck that handlebar is straightCheck pressure in each tiresAlways follow recommended pressurePlace rope around the vehicle and using an elastic, link both ends togetherInstall spacers on rear rimsThese spacers will prevent the rope from touching the tires
NOTE: Use the same procedure for RH and LH side
Removal
Place the vehicle on jack stands and remove the appropriate wheelRemove cotter pin no20 (discard), elastic nut no21 and hardened washers no22
Inspection
Inspect ball joint ends for wear or looseness, if excessive, replace