2004 Bombardier Outlander 330/400 Factory Service Manual, Page 242Get this manual
Section 05 ELECTRICAL Subsection 06 (INSTRUMENTS AND ACCESSORIES)
Properly reinstall removed parts in the reverse order of their removal
Removal
NOTE: Use the same procedure for RH or LH headlampUnplug the headlamp connectorRemove both knobsRemove the last screw retaining headlamp holder
V04G0GA
TYPICAL 1Beam height adjustment 2Beam side adjustment
HEADLAMP BEAM AIMING
Select high intensityBeam aiming is correct when center of high beam is 131 mm (5 in) below the headlamp horizontal center line, scribed on test surface, (17 ft) awayNOTE: Sit down the driver or place the same weight on the vehicleMeasure headlamp center distance from groundScribe line at this height on test surface (wall or screen)Light beam center should be 131 mm (5 in) below scribed line