2004 Bombardier Outlander 330/400 Factory Service Manual, Page 194Get this manual
Section 03 ENGINE Subsection 12 (CVT)
Disassembly of Driven Pulley
Fixed Half Remove retaining ring no23 and lift torque gear no24NOTE: The following procedure is not necessary except if ball bearing or shaft must be removedRefer to INSPECTION before proceedingHeat ball bearing area up to 100C (212F) before removing ball bearingUse soft hammer to push shaft no25 with bearing no26 out of fixed half1 2
CAUTION: To avoid damage, make sure cleaner does not contact the countershaft sealR400motr182A
1Main shaft support 2Sealing lip of countershaft oil seal
Inspection
Sliding Half Check bushings no27 for cracks, scratch and for free movement when assembled to sliding halfUsing dial bore gauge, measure bushing diameterMeasuring point must be at least mm (14 in) from bushing edgeThis bushing is not replaceableReplace sliding half if bushings no27 are out of specificationVisually inspect coatings1