2004 Bombardier Outlander 330/400 Factory Service Manual, Page 183Get this manual
Section 03 ENGINE Subsection 11 (GEARBOX)
NOTE: The alligator clip is recommendedReplace wire harness no54 if damaged, brittle, hard or otherwise damagedIf the shifting indicator switch and its harness are good, check the vehicle harness andor indicator lights
Inspection
Check if starter drive pinion is free of movementNOTE: Centrifugal weights avoid disengaging of the pinion while starting the engine3 2
Installation
For installation, reverse the removal procedurePay attention to the following detailsIf all switches are removed, take care to put back wires at the proper locationTake care do not damage shifting indicator switches threads during installationR400motr217A
STARTER DRIVE PINION
Removal
Remove: drive pulley (refer to CVT) screw no53 retaining starter drive pinion cover NOTE: Do not lose shims no50, no52 andor spring no49 during removal of starter pinion cover starter drive pinion cover no51 starter drive pinion no48