2004 Bombardier Outlander 330/400 Factory Service Manual, Page 134Get this manual
Subsection 09
Section 03 ENGINE (CYLINDER AND HEAD)
Push in rocker arm shaft no11 until its chamfer reaches the end of rocker arm bore
R400motr66B
1Rocker arm shaft 2Thrust washer (MAG side) 3Thrust washer (PTO side)
Place the other thrust washer no16 and push rocker arm shaft to end positionInstall the other rocker arm by using the previous procedureInstall the camshaft retaining plate no26Install all other removed parts
NOTE: Before removing cylinder head, blow out remaining coolant by air pressureDuring cylinder head removal, the remaining coolant in cylinder head could overflow into the engine and little quantity of coolant could drop into the engineIn this case, the engine oil will be contaminatedDisconnect: spark plug wire temperature switch connectorsRemove: both side panels and both inner fenders (refer to BODY) exhaust pipe spring exhaust pipe nuts radiator inlet hose carburetor clamp (cylinder head side only) chain tensioner (see CHAIN TENSIONER above) valve cover and profile sealing ring (see VALVE COVER above) camshaft timing gear cylinder head screws no28 cylinder head screws no27 retaining cylinder head and cylinder to cylinder base