2004 Bombardier DS650/DS650 Baja/DS650 Baja X Shop Manual, Page 231Get this manual
Section 10 BODYFRAME Subsection 02 (BODY)
Baja Models only Installation is the reverse of the removal but pay attention to the following: align skid plate no46 then secure it starting with middle square hole; tighten loosely then secure in this sequence: forward square hole, forward round holes and rearward round holes; tighten loosely validate proper positioning of skid plate, then torque all bolts and nuts safely lower vehicle back on the ground
On wheel side, secure with bolt no52 and nut no51Fully turn the handlebar into both directions and check for interferenceFully compress front suspension and check for interferenceAdjust as necessary, secure in place and torque fasteners
NERF BAR
Removal WARNING
Engine and muffler must be cold before removing the nerf barOtherwise, serious injuries may occurBaja Models only
A-ARM PROTECTOR PLATE
Removal
Baja Models only Procedure for RH and LH side is the sameRemove the A-arm protector retaining nuts no49, and no51 and U-clamps