2004 Bombardier DS650/DS650 Baja/DS650 Baja X Shop Manual, Page 168Get this manual
Section 06 DRIVE TRAIN Subsection 02 (FRONT DRIVE)
GENERAL
For installation, use the torque values and Loctite products from the exploded viewsClean threads before using Loctite when installing the screws
WARNING
Torque wrench tightening specifications must strictly be adhered toLocking devices (ex locking tabs, elastic stop nuts, self-locking fasteners, etc must be installed or replaced with new ones where specifiedIf the efficiency of locking device is impaired, it must be replaced
Install new cotter pinBoth ends of cotter pin must be foldedCAUTION: Make sure each end of cotter pin does not protrude too far and rubs against the wheel capReinstall wheel cap
WHEEL HUB BEARING
Inspection
Check inner race of each bearing no2 with fingerThe bearing should turn smoothly and quietlyCheck if bearing outer race fits tightly in the hubRemove and discard bearings if races do not turn smoothly and quietly or if they fit loosely in hubReplace bearings and hub if bearings fit loosely into hubNOTE: Replace wheel hub bearings in pairsDo not reuse old bearings