2003 Bombardier Rally 200 Service Manual, Page 272Get this manual
Section 10 BODYFRAME Subsection 03 (FRAME)
GENERAL
For installation, use the torque values and Loctite products from exploded viewsClean threads before using Loctite product when installing screwsCAUTION: Before performing electrical welding anywhere on the vehicle, unplug the electronic module connectorAlso unplug the negative cable and the voltage regulatorThis will protect the electronic module and battery against damage caused by flowing current when welding
Installation
Installation is the reverse of removal procedure
Cleaning
Clean frame no1 with appropriate cleaners and rinse with high pressure hoseNOTE: Clean the draining holes under frameThe drain holes are located at the rear of bottom side of frameTouch up all metal spots where paint has been scratched offSpray all bare metal parts of vehicle with metal protector
FRONT PLATE
Removal
Remove front bumper, front fascia and front luggage rackRefer to BODYRemove screws no3 and screws no4