2003 Bombardier Rally 200 Service Manual, Page 248Get this manual
Section 08 SUSPENSION Subsection 03 (REAR SUSPENSION)
GENERAL
At installation, use torque values and Loctite products from the exploded viewClean threads before using Loctite products when installing screws
Push down on handle until it locksRemove spring stopper and cap then release handle
WARNING
Torque wrench tightening specifications must strictly be adhered toLocking devices (ex locking tabs, elastic stop nuts, self-locking fasteners, etc must be installed or replaced with new ones where specifiedIf the efficiency of locking device is impaired, it must be renewed
REAR SHOCK
Removal
Lift rear of vehicle until rear shock absorber no1 is fully extendedInstall jack stands or blocks under the frame to support the vehicleRemove upper no2 and lower no3 bolts and nuts no4 retaining shock absorber3
A01B4LA
TYPICAL 1Clevis pin 2Bar 3Handle horizontal