2003 Bombardier Rally 200 Service Manual, Page 244Get this manual
Section 08 SUSPENSION Subsection 02 (FRONT SUSPENSION )
GENERAL
At installation, use torque values and Loctite products from the exploded viewClean threads before using Loctite products when installing screws
Close and lock the barAdjust the handle horizontal position by changing the position of the clevis pin
WARNING
Torque wrench tightening specifications must strictly be adhered toLocking devices (ex locking tabs, elastic stop nuts, self-locking fasteners, etc must be installed or replaced with new ones where specifiedIf the efficiency of locking device is impaired, it must be renewed
FRONT SHOCK
Removal
Lift front of vehicle until rear shock absorbers are fully extended then install jack stand under the frame to support the vehicle off the groundNOTE: Do not remove front wheels to remove the front shocksRemove lower bolt no3 then upper bolt no2 of shock no13
A01B4LA