2003 Bombardier Rally 200 Service Manual, Page 229Get this manual
Section 06 DRIVE TRAIN Subsection 02 (REAR AXLE)
Remove LH rear wheel and wheel hubPull out the rear axle with rear sprocket no3 from drive chain tensioner no4
NOTE: The drive pinion must be installed with the lip toward the outside of vehicle
Installation
CAUTION: Replace chain, engine sprocket and rear sprocket together to prevent rapid chain and sprockets wearInstall new tab washer each time the engine sprocket is removedFor installation, reverse the removal procedure
REAR SPROCKET HUB
Removal
V06H0BA
Rear axle Chain tensioner Rear sprocket Rear sprocket hub
Lift rear of vehicle and install jack stands under the frame to support the rear of vehicle off the groundPush down the rear sprocket hub no2 on rear axle to get access of retainer ring no10