2003 Bombardier Rally 200 Service Manual, Page 223Get this manual
Section 05 ELECTRICAL Subsection 06 (INSTRUMENTS AND ACCESSORIES)
Installation
For installation, reverse the removal procedure
ELECTRONIC MODULE
Refer to IGNITION SYSTEM for testing procedures
Removal
The electronic module is located on the front frame under front luggage rackTo remove, unscrew bolts retaining electronic module to frame and unplug the connectors
Installation
For the installation, reverse the removal procedure
TEST MULTI-FUNCTION SWITCH
Apply parking brake, place transmission lever in NEUTRAL position and start engine
Headlight Switch Select low beam position on headlight switchUsing multimeter, measure the voltage between GREEN and BLACK wiresThe obtained value should be between 12 and 14.5 VdcPlace the headlight switch selector on high beam positionMeasure the voltage between BLUE and BLACK wiresThe obtained value should be between 12 and 14.5 Vdc No voltage: Check wiring condition and headlight switch Voltage is good: Change headlight bulb(s)Using multimeter, measure the resistance between the following wiresPOSITION Switch to LO Switch to HI WIRE YELLOWRED and GREEN YELLOWRED and BLUE RESISTANCE 0.2 0.2 max0.2 0.2 max