2003 Bombardier Rally 200 Service Manual, Page 189Get this manual
Section 04 FUEL SYSTEM Subsection 03 (CARBURETOR )
CARBURETOR FLOAT LEVEL ADJUSTMENT Float level 15 mm 1mm (.591 in .039 in)
Installation
To install carburetor on engine, inverse removal procedure, as described: Adjust the throttle cable, then install the carburetor capRefer to CARBURETOR ADJUSTMENTS below in this sectionCarefully replace carburetor cap no2 in its original positionMake sure valve piston no5 groove passes the inside protrusion in carburetor no3 before closing the carburetor cap no2
V06F0HA
1Gauge tips 2"L" arm AHeight
WARNING
Throttle valve piston groove must be aligned with carburetor inside protrusion to allow throttle valve piston to reach idle bottom positionOtherwise throttle valve piston should be half open leading to potential dangerous situation