2003 Bombardier Rally 200 Service Manual, Page 159Get this manual
Section 03 ENGINE Subsection 10 (GEARBOX)
NOTE: Use small, flat screwdriver to remove oil seals from MAGPTO sideCAUTION: Pay attention not to damage CVT main shaft during removal of oil seals oil seals no6 and no5 on engine MAGPTO side
Inspection
Check bearings behind each oil seal for contamination andor metal shavingsCheck surface on CVTmain shaft in oil seal area for grooves and replace if necessary (see GEAR BOX below)
Installation
The installation is the reverse of removal procedurePay attention to the following detailsCAUTION: Place small rag to avoid ball bearing contamination due to metal shavingsPrepare chamfer with three-square scraper to ease placing oil seals no5 and no6NOTE: Size of the chamfer should be approximately 30R175motr112A