2003 Bombardier Rally 200 Service Manual, Page 146Get this manual
Section 03 ENGINE Subsection 09 (CRANKSHAFT)
GENERAL
For installation, use the torque values and Loctite products from the exploded viewsClean threads before using Loctite when installing the screws
Turn rotor, fixed on crankshaft MAG side, to TDC compression position (refer to CYLINDER AND HEAD)Use screwdriver to check if groove in crankshaft is aligned with the hole
WARNING
Torque wrench tightening specifications must strictly be adhered toLocking devices (ex locking tabs, elastic stop nuts, self-locking fasteners, etc must be installed or replaced with new ones where specifiedIf the efficiency of locking device is impaired, it must be renewed