2003 Bombardier Rally 200 Service Manual, Page 106Get this manual
Section 03 ENGINE Subsection 06 (MAGNETO SYSTEM)
Inspection
Check magneto cover for cracks or other damagesReplace if necessary
Install new gasket on the magneto coverTightening sequence for screws on magneto cover is as per following illustration8 6
Installation
Remove all residues on mating surfacesThe mating surfaces must be cleaned of any contaminationsNOTE: Clean all metal component in non-ferrous metal cleanerUse Bombardier gasket remover (PN 413 708 500), or suitable equivalent
WARNING
Wear safety glasses and work in well ventilated area when working with strong chemical productsAlso wear suitable non-absorbent gloves to protect your handsFor installation, reverse the removal procedureHowever, pay attention to the followingIMPORTANT: Apply small amount of silicon on mating surface in grommet area before placing the gasket2 3