2003 Bombardier Rally 200 Service Manual, Page 51Get this manual
Section 02 MAINTENANCE Subsection 03 (MAINTENANCELUBRICATION)
WARNING
Never run engine in an enclosed areaNever perform this operation immediately after the engine has been run because exhaust system is very hotMake sure that there are no combustible materials in the areaWear eye protector and glovesNever stand behind the vehicle while purging exhaust systemRespect all applicable laws and regulationsPlace transmission on NEUTRAL position and apply parking brakeRemove the screw retaining the spark arrester to mufflerPull the spark arrester out of muffler
R175motr131A
1Inlet bore from oil pump to oil filter 2Outlet bore to engine oil provinding system 3Oil line to pressure regulator valve
Install filter cover and torque screw to 10 Nm (89 lbfin)Wipe out any oil spillage on engineInspect gasket on drain plug and replace as necessaryClean gasket area on engine and drain plug then reinstall plugRefill engine at the proper level with the recommended oilRefer to TECHNICAL DATA for capacityDo not overfillStart engine and let idle for few minutesEnsure oil filter area and drain plug areas are not leakingStop engineWait while to allow oil to flow down to crankcase then check oil levelRefill as necessaryDispose oil as per your local environmental regulations