2003 Bombardier Outlander 400 Factory Service Manual, Page 265Get this manual
Section 06 DRIVE TRAIN Subsection 03 (REAR AXLE)
Installation
Install new U-joint cross in inner yokeInstall new bearing cap by handNOTE: Carefully install U-joint cross with grease fitting properly positioned
Install snap ringRepeat procedure for other sidesGrease U-joint, using grease gun with SHELL, Alvania EP-2 grease only
REAR DIFFERENTIAL
Removal
Install jack stand under differential to support the vehicle during the following procedureRemove: rear wheels trailing arms drive shafts central protector no8 lower differential bolts no12 hitch upper differential bolts no13 rear propeller shaft bolt no14 and washer no15 differential no10
V01H10A
Tighten vise to force bearing caps in