2003 Bombardier Outlander 400 Factory Service Manual, Page 179Get this manual
Section 03 ENGINE Subsection 12 (CVT)
To remove belt no4, slip the belt over the top edge of sliding half, as shown
Installation
For installation, reverse the removal procedurePay attention to following detailsThe maximum drive belt life span is obtained when the drive belt has the proper rotation directionInstall it so the arrow printed on belt is pointing towards the back of the vehicleNOTE: Put small amount of Loctite 5910 in the groove of CVT cover to ease installation of CVT cover with gasket no3Install the center top screw of cover in firstInstall the other screws then torque them in crisscross sequence
DRIVE PULLEY