2003 Bombardier Outlander 400 Factory Service Manual, Page 176Get this manual
Section 03 ENGINE Subsection 11 (GEARBOX)
Place one probe of multimeter on the pin and the other on the opposite side of wire harness (specific cable)NOTE: The alligator clip is recommendedReplace wire harness no56 if damaged, brittle, hard or otherwise damagedIf the shifting indicator switch and its harness are good, check the vehicle harness andor indicator lights
Inspection
Check if starter drive pinion is free of movementNOTE: Centrifugal weights avoid disengaging of the pinion while starting the engine3 2
Installation
For installation, reverse the removal procedurePay attention to the following detailsIf all switches are removed, take care to put back wires at the proper locationTake care do not damage shifting indicator switches threads during installation
R400motr217A
1Starter drive pinion 2Starting position (spring released) 3Gear is engaged Drive pulley fixed half (spring loaded)