2003 Bombardier Outlander 400 Factory Service Manual, Page 152Get this manual
Section 03 ENGINE Subsection 10 (CRANKSHAFTBALANCER SHAFT)
Connecting Rod Big End Radial Play NOTE: Prior to remove connecting rod from the crankshaft, mark big end halves together to ensure correct reinstallation (cracked surface fits in only one position)Remove connecting rod no6 from crankshaft no3CAUTION: Always replace connecting rod screws no7 if removing the connecting rodIt is recommended to replace bushings no8, in case of installing the connecting rod
Do the torque procedure as described further
R400motr33A
AConnecting rod big end bushing
R400motr31A
CRANKSHAFT PIN DIAMETER NEW MINIMUM NEW MAXIMUM SERVICE LIMIT 40.009 mm (1.575 in) 40.025 mm (1.576 in) 39.980 mm (1.574 in)