2003 Bombardier Outlander 400 Factory Service Manual, Page 120Get this manual
Section 03 ENGINE Subsection 09 (CYLINDER AND HEAD)
VALVE COVER
Removal
Remove: valve cover screws no1
Installation
For installation, reverse the removal procedureInstall the valve cover screws in criss-cross sequenceInstall new profile sealing ring in valve cover
VALVE ADJUSTMENT
Lock crankshaft at the TDC compression position (refer to CRANKSHAFTBALANCER SHAFT, see CRANKSHAFT LOCKING PROCEDURE)Remove valve cover (refer to VALVE COVER above)Hold adjusting screw no14 and loosen locking nut no13Using feeler gauge, check the valve clearance3 1
R400motr52A
1Valve cover screws 2Water temperature switch
valve cover no2 and profile sealing ring no32 1