2003 Bombardier Outlander 400 Factory Service Manual, Page 107Get this manual
Section 03 ENGINE Subsection 07 (MAGNETO SYSTEM)
NOTE: There is only one position for the stator (notch in the magneto housing cover)Inspection
Check the CPS condition and replace it if necessaryTo test the sensor refer to IGNITION SYSTEM
Installation
For installation, reverse the removal procedure2
Removal
Lock crankshaft with locking bolt (PN 529 035 617)Refer to CRANKSHAFTBALANCER SHAFTRemove: magneto housing cover no6 nut no12 retaining rotor no14 serrated washer no13
R400motr13A
1Thread for cable holding strip 2Notch for stator
CPS (Crankshaft Position Sensor)
The CPS is located on the top of magneto housing cover, behind the exhaust pipe support1 3