2003 Bombardier Outlander 400 Factory Service Manual, Page 103Get this manual
Section 03 ENGINE Subsection 07 (MAGNETO SYSTEM)
GENERAL
The engine removal is necessary to work on magneto components except for the CPS (Crankshaft Position Sensor) and oil sealAlways perform the electric tests before removing or installing whatever componentFor installation, use the torque values and Loctite products from the exploded viewsClean threads before using Loctite when reinstalling the screws
screws nos3, and 5
MAGNETO HOUSING COVER
Removal
Remove engine from vehicleRemove disconnect unitLock crankshaft at TDC (refer to CYLINDER AND HEAD)Remove: rewind starter (refer to REWIND STARTER) water pump cover (refer to COOLING SYSTEM) electric starter screws no1 screws no2 holding output shaft cover in place NOTE: Only remove the two front screws no2To ease lifting the magneto cover it is recommended to loosen the screws behindR400motr02A