2003 Bombardier Outlander 400 Factory Service Manual, Page 96Get this manual
Section 03 ENGINE Subsection 05 (COOLING SYSTEM)
Removal
Remove: LH inner fender (refer to BODY) coolant tank support bolt no19
TEMPERATURE SENDER
Remove temperature sender no18, see below for procedurePut the temperature sender in water and heat waterUsing multimeter, check the resistance from temperature senderTemperature sender should open when water temperature reaches the following degreeWater temperature 85C (185F)
Change temperature sender if resistance does not change when water temperature is equal or over specification
Removal
V07C0SA
overflow hose no12 coolant tank no15Empty coolant tank
Drain coolantRemove the LH inner fender (refer to BODY)Unplug temperature sender connector
Installation
The installation is the reverse of the removal procedure