2003 Bombardier Outlander 400 Factory Service Manual, Page 80Get this manual
Section 03 ENGINE Subsection 04 (REMOVAL AND INSTALLATION)
From the top side, connect the following: indicator switches VSS engine pressure switch brake switch disconnect unit CPS magnetoOn left side of vehicle, install the following: upper engine support exhaust pipe nut NOTE: Install new gasket before screwing the exhaust pipe carburetor carburetor fuel line choke cable CVT inlet and outlet hoses radiator outlet hose air box inner fender footrestOn right side of vehicle, install or connect the following: rear propeller shaft bolt air box screw blow-by hose carburetor clamps carburetor vent hose impulse line radiator inlet hose throttle cable temperature switch connector RED starter cable engine ground cables NOTE: Do not forget the star washer link rod NOTE: The transmission lever must be on PARK exhaust support engine cover
Final Assembly Procedure Install console, LH and RH side panels then seatMake sure coolant and oil drain plugs are reinstalled and tightFill cooling systemRefer to COOLING SYSTEMFill engine with the right amount of oilPut oil of appropriate viscosityReconnect battery