2003 Bombardier Outlander 400 Factory Service Manual, Page 11Get this manual
INTRODUCTION
Adjusting Screw
NOTE: Retaining compound is always forced out when applied on shaft3DO NOT use anti-seize Loctite or any similar product4No curing period is requiredMounting in Tandem 1Apply retaining compound on internal element bore2Continue to assemble as shown above
Case-In Components
Metallic Gaskets
A00A3PA
1Apply here 2Plunger
1Adjust screw to proper setting2Apply drops of proper strength Loctite threadlocker on screwbody contact surfaces3Avoid touching metal with tip of flaskNOTE: If it is difficult to readjust, heat screw with soldering iron (232C (450F))
Mounting on Shaft