2002 Traxter Autoshift XL/XT Shop Manual, Page 342Get this manual
Section 03 ENGINE Subsection 10 (GEARBOX)
GEARBOX
THIS PROCEDURE MUST BE USED WITH THE QUEST SERIES
OUTPUT SHAFT AXIAL CLEARANCE
NOTE: In the 2002 Shop Manual Quest, page 0310-5, the procedure to adjust the output shaft axial clearance has been modifiedAdjust the axial play as per following procedure: 1Use soft hammer to put the output shaft bearing in its place, against the crankcase MAG side
V04C1IA
1Crankcase housing (MAG side) 2Previously cleaned surface 3Bearing alignment tool