2002 Traxter Autoshift XL/XT Shop Manual, Page 272Get this manual
Section 10 BODYFRAME Subsection 03 (FRAME)
WINCH LATCH
Removal
Remove front skid plate and front bumperRefer to BODYRemove flanged bolts no10
Cleaning
Clean frame no5 and rear frame extension with appropriate cleaners and rinse with high pressure hoseTouch up all metal spots where paint has been scratched offSpray all bare metal parts of vehicle with metal protector
Welding
Steel Frame: electric welding amperage: 70110 voltage: 2024 rod: E-7014 (332 in)CAUTION: Before performing electrical welding anywhere on the vehicle, unplug the AMP connectors at the MPEMAlso unplug the negative cable and the voltage regulatorThis will protect the MPEM and battery against damage caused by flowing current when weldingNOTE: Install the ground as close as possible from the reparation areaCAUTION: If welding is to be done near plastic material, it is recommended to either remove the part from the area or to protect it with aluminum foil to prevent damage