2002 Traxter Autoshift XL/XT Shop Manual, Page 241Get this manual
Section 09 BRAKES Subsection 02 (HYDRAULIC BRAKES)
There are four hollow places on one set of brake padsWhen the pad wear reaches one of the hollow places, the pad must be changed even if the pad wear does not reach another hollow placeV02K0FA
1Hollow place
BRAKE PAD MINIMUM THICKNESS
1 mm (132 in)
Install new brake padsInstall new pad pins by pushing in the pads against pad spring to align pad slots in the pads and caliper bodyInstall brake caliper so the disc is positioned between padsNOTE: Be careful not to damage pads and that pads are correctly inserted in their locationAfter the job is completed, firmly depress the brake lever few times to bring the pads in contact with the discCheck for leaks and make sure the brakes operate normally before drivingThe pads must rest flat on the disk
WARNING
Avoid getting oil or grease on brake padsContaminated brake pads can affect stopping capacitiesCAUTION: Brake pads must always be replaced in pairs
BRAKE DISC