2002 Traxter Autoshift XL/XT Shop Manual, Page 229Get this manual
Section 08 SUSPENSION Subsection 03 (REAR SUSPENSION)
Push down on handle until it locksRemove spring stopper and cap then release handle
Inspection
Secure the shock body end no2 in vise with its rod upward1 2
A14F0BA
TYPICAL 1Clamp here
A01B4LA
TYPICAL 1Clevis pin 2Bar 3Handle horizontal
At installation, cap opening no8 must be 180 from spring stopper opening no7
CAUTION: Do not clamp directly on shock bodyExamine each shock for leaksExtend and compress the piston several times over its entire strokeCheck that it moves smoothly and with uniform resistance with its rod upwardPay attention to the following conditions that will denote defective shock: skip or hang back when reversing stroke at mid travel Seizing or binding condition except at extreme end of either stroke Oil leakage gurgling noise, after completing one full compression and extension strokeRenew if any faults are present