2002 Traxter Autoshift XL/XT Shop Manual, Page 208Get this manual

2002 Traxter Autoshift XL/XT Shop Manual, Page 208

Section 06 DRIVE TRAIN Subsection 03 (REAR AXLE)
Pinion Gear and Ring Gear Recentering
NOTE: All measurements require great care and absolute cleanliness if accurate results are to be obtainedFirst; center pinion gearMeasure distance between pinion gear surface to low point of carrier bearingThis is measure "A"
V01H1KA

The measure "B" is given value of 64.450 mm (2.5374 in)Subtract the largest value of "A" or "B" by the smallest valueThis result is the value "C"Locate value "C" in the following chart and select the proper shimsVALUE "C" 0.000 to 0.073 mm (.0000 to .0029 in) 0.076 to 0.124 mm (.0030 to .0049 in) 0.127 to 0.175 mm (.0050 to .0069 in) 0.177 to 0.226 mm (.0070 to .0089 in) 0.228 to 0.276 mm (.0090 to .0109 in) 0.279 to 0.327 mm (.0110 to .0129 in) 0.330 to 0.378 mm (.0130 to .0149 in) SHIM QUANTITY SHIM THICKNESS 0.51 mm (.020 in) 0.51 mm (.020 in) 0.56 mm (.022 in) 0.51 mm (.020 in) 0.56 mm (.022 in) 0.51 mm (.020 in) 0.56 mm (.022 in) 0.25 mm (.010 in) 0.38 mm (.015 in) 0.51 mm (.020 in) 0.56 mm (.022 in) 0.25 mm (.010 in) 0.38 mm (.015 in) 0.51 mm (.020 in) 0.56 mm (.022 in) 0.25 mm (.010 in) 0.38 mm (.015 in) 0.56 mm (.022 in) 0.25 mm (.010 in) 0.51 mm (.020 in) 0.56 mm (.022 in) SHIM PACK THICKNESS 1.53 mm (.0602 in) 1.58 mm (.0622 in) 1.58 mm (.0622 in) 1.63 mm (.0642 in) 1.65 mm (.0649 in) 1.68 mm (.0661 in) 1.7 mm (.0669 in)