2002 Traxter Autoshift XL/XT Shop Manual, Page 206Get this manual
Section 06 DRIVE TRAIN Subsection 03 (REAR AXLE)
Installation For installation, reverse the removal procedurepaying attention to the following detailsApply grease (PN 293 550 019) on splinesTorque castellated nut no.11 to 140 Nm (103 lbfft) minimumApply Loctite 609 on bolts no6 and no7NOTE: Always install new cooter pin when the axle is reinstalled
REAR PROPELLER SHAFT
Removal
Remove swing arm with rear axle assemblyRefer to REAR SUSPENSIONRemove the propeller shaft bolt no14 and flat washer no15Separate rear propeller shaft no16 from engine