2002 Traxter Autoshift XL/XT Shop Manual, Page 201Get this manual
Section 06 DRIVE TRAIN Subsection 02 (FRONT DRIVE)
Support inner yoke in vice and drive other yoke down with soft hammer
V01H11A
V01H0ZA
Support U-joint in vice and drive inner yoke down to remove remaining bearing capsRemove U-joint crossInstallation Install new U-joint cross in inner yokeInstall new bearing cap by handNOTE: Carefully install U-joint cross with grease fitting properly positioned
Using suitable tappet, fully seat bearing cap in one sideContinually, check for free movement of bearing cross as bearing caps are assembled
V01H12A