2002 Traxter Autoshift XL/XT Shop Manual, Page 189Get this manual
Section 05 ELECTRICAL Subsection 07 (INSTRUMENTS AND ACCESSORIES)
SPEEDOMETER (if so equipped)
Using multimeter, measure the voltage between REDGREY and BLACKBROWN wiresTurn ignition switch to ONThe obtained value should be between 12 and 14.5 Vdc
WINCH CONTROL SWITCH (if so equipped)
Remove power cables under winch control switchNOTE: Identify the position of the power cables for the installationUse multimeter on beeper position to check the following items: Check the continuity between terminal no2 and positive (+) terminal when the switch is turned on IN position Check the continuity between terminal no1 and positive (+) terminal when the switch is turned on OUT position Check the continuity between terminal no2 and negative (-) terminal when the switch is turned on OUT position Check the continuity between terminal no1 and negative (-) terminal when the switch is turned on IN position Check the continuity between terminal no1 and terminal no2 when the switch is not turned on any position