2002 Traxter Autoshift XL/XT Shop Manual, Page 179Get this manual
Section 05 ELECTRICAL Subsection 06 (HYDRAULICELECTRIC SHIFT SYSTEM)
Remove screws and lock washers retaining STPS on enginePull STPS
Installation
For installation, reverse the removal procedurePay attention to the following details: Check O-ring and change if necessary Align interior of the STPS and engine shaft Place connector on topSecure with screws and lock washersApply Loctite 243 on threads Torque screws to Nm (18 lbfin) Calibrate STPSRefer to DIAGNOSTIC CALIBRATION MODE section, task 5
Remove engine oilRefer to MAINTENANCE LUBRICATIONUnplug VSSRemove engine bolt under VSS
GBPS (Gear Box Position Sensor)
The GBPS is located on rear of engine
Refer to SENSORS TESTS section
Removal
Unplug GBPSRemove screws and reinforcementsPull GBPS
V01C2LC
TYPICAL 1Remove this bolt in first
Installation