2002 Traxter Autoshift XL/XT Shop Manual, Page 170Get this manual
Section 05 ELECTRICAL Subsection 06 (HYDRAULICELECTRIC SHIFT SYSTEM)
Task 3: Sensors and Solenoids Verification
The MPEM reads all main power supply outputs during operation of the vehicleIf any abnormality occurs, the MPEM will record the information in registerThe diagnostic components register is displayed with the LED "Hi-Lo beam"The LED "Reverse" is ON during all the time the MPEM is verifying the diagnostic memoryEach abnormal components is represented by coded number (see table below) and each code number correspond to the number of blinks that the LED "Hi-Lo bean" is doingWhen there are two or more abnormal items, the lowest coded numbered item is first indicated and delay of seconds separates each following codeWhen problem happens, all leds blink in the dashboard to show that there is problem and will do so until the key switch is turned offThe corresponding register is increased when problem happenAlways clear all codes and re-run vehicle to be sure code(s) will re-appearBLINK