2002 Traxter Autoshift XL/XT Shop Manual, Page 128Get this manual
Subsection 03
Section 04 FUEL SYSTEM (CARBURETOR AND FUEL PUMP)
Adjustment
To adjust the cable tension, squeeze the base of rubber bellows and screw or unscrew the plastic jam nut located under rubber bellows
Verification
Connect clean plastic tubing to the inlet nipple and alternately apply pressure and vacuum with pump of leak test kitThe inlet valve should release with pressure and hold under vacuumRepeat the same procedure at the outlet nippleThis time the outlet valve should hold with pressure and release under vacuumCheck impulse diaphragm and gasket on highsupply fuel pump with twin outlets as follows: Connect clean plastic tubing to the impulse nipple and plug vent hole on top coverEither apply pressure or vacuumThe diaphragmgasket must not leak
Cleaning and Inspection
V04F0PA
FUEL PUMP
Removal