2002 Traxter Autoshift XL/XT Shop Manual, Page 124Get this manual
Subsection 03
Section 04 FUEL SYSTEM (CARBURETOR AND FUEL PUMP)
Refer to following photos for proper float level gauge positioning and to TECHNICAL DATA for proper level
Installation
NOTE: On the AUTOSHIFT model, the TPS sensor calibration is necessaryAdjust the idle speed in first, then, calibrate the TPS sensorRefer to ELECTRIC SHIFT SYSTEMTo install carburetor on engine, inverse removal procedure, as described: Inspect throttle and choke cable housing prior to installation Reinstall throttle and choke cables, at the same time adjust the throttle cable, then install the side coverRefer to CARBURETOR ADJUSTMENTS below in this section Reinstall carburetor on engineWhen reinstalling carburetor on engine, pay attention to the following: CAUTION: The rubber flanges must be checked for cracks andor damageAt assembly, the rubber flanges must be perfectly matched with the air box, carburetor and engine or severe engine damage will occurDo not use screwdriver or other tool to install the rubber flangesInstall clamps in way that their tightening bolts are staggered not aligned