2002 Traxter Autoshift XL/XT Shop Manual, Page 87Get this manual
Subsection 08
Section 03 ENGINE (LUBRICATION SYSTEM)
Lubricate the rubber gasket on the filter with engine oilInstall the new filter then screw one full turn after rubber gasket makes contactWipe out any oil spillage on engineChange gasket on drain plugClean gasket area on engine and drain plug then reinstall plugRefill engine at the proper level with the recommended oilRefer to TECHNICAL DATA for capacityStart engine and let idle for few minutesEnsure oil filter area and drain plug areas are not leakingStop engineWait while to allow oil to flow down to crankcase then check oil levelRefill as necessaryDispose of oil as per your local environmental regulations
V01C1UA
1Engine oil pressure regulator
OIL STRAINER
Removal
Ensure vehicle is on level surfaceRemove: skid plate under vehicle engine oil screws no1 retaining oil strainer cover no2 oil collector no3 and O-ring no4 oil strainer no5
The pressure should be between 101 kPa (14.7 PSI) and 500 kPa (72.5 PSI)
Removal