2002 Traxter Autoshift XL/XT Shop Manual, Page 68Get this manual
Section 03 ENGINE Subsection 04 (REMOVAL AND INSTALLATION)
With muffler secured in its rubber mounts, fit exhaust pipe, securing it loosely at its flange and on engineTighten flange nuts, making sure exhaust pipe is properly aligned inside muffler ball socket then install retaining springs after pushing muffler forward in exhaust pipeTighten exhaust pipe support bolt
Muffler Removal
All Models except XL Remove heat shield no23 and exhaust pipe no3Pull muffler no26 forward, pull out retaining rod from supports and remove muffler
V01C19A
TYPICAL TRAXTER SHOWN 1Retaining springs
Pull exhaust pipe forward
Exhaust Pipe Installation