2002 Traxter Autoshift XL/XT Shop Manual, Page 67Get this manual
Section 03 ENGINE Subsection 04 (REMOVAL AND INSTALLATION)
EXHAUST SYSTEM
WARNING
Never touch exhaust system components immediately after the engine has been run because these components are very hot
Heat Shield Installation
For installation, reverse the removal procedureAll Models except XL First, install bottom screw then rear screw, do not tighten yetInstall the screws on top of heat shieldTorque all screws to Nm (62 lbfin)
Heat Shield Removal
All Models except XL Remove the rear fenderRefer to BODYRemove screws no22 retaining heat shield no23XL Model Heat Shield Pipe Tip up the rear cargo boxRemove screws no22 retaining heat shields no24 to muffler no26