2002 Traxter Autoshift XL/XT Shop Manual, Page 16Get this manual
INTRODUCTION
Case-In Components
Metallic Gaskets
TIGHTENING TORQUES
Tighten fasteners to torque mentioned in exploded views and textWhen they are not specified refer to following table.The table also gives the metric conversionIn order to avoid poor assembling, tighten screws and bolts in accordance with the following procedure: 1Manually screw all screws, bolts andor nuts2Apply the half of the recommended torque value3Torque at the recommended torque valueNOTE: Always torque screws, bolts andor nuts in criss-cross sequenceBOLT OR NUT SIZE M4 M5 M6 BOLT OR NUT SIZE M8 M10 M12 M14 TIGHTENING TORQUE Nm 10 lbfin 18 35 89
A00A3VA