2002 Traxter Autoshift XL/XT Shop Manual, Page 15Get this manual
INTRODUCTION
Preassembled Parts
1Adjust screw to proper setting2Apply drops of proper strength Loctite threadlocker on screwbody contact surfaces3Avoid touching metal with tip of flaskNOTE: If it is difficult to readjust, heat screw with soldering iron (232C (450F))
Mounting on Shaft
Mounting with Press
A00A3OA
1Apply here 2Do not apply
1Clean bolts and nuts with solvent2Assemble components3Tighten nuts4Apply drops of proper strength Loctite on boltnut contact surfaces5Avoid touching metal with tip of flaskNOTE: For preventive maintenance on existing equipment, retighten nuts and apply proper strength Loctite on boltnut contact surfacesAdjusting Screw