2002 Bombardier Traxter Factory Service Manual, Page 261Get this manual
Section 10 BODYFRAME Subsection 02 (BODY)
SEAT ADJUSTMENT
Autoshift and XT Models For latch stud no71 adjustment, unscrew the latch stud nut no72 and screw or unscrew the latch stud to the best heightSee the following illustration2
V01L1SA
1Lock pin 2Adjustment nut (apply Loctite 271) A38 mm (1-12 364 in)
XL Model
To adjust the latch studs: Make sure the box is closed properly (latched on each side)If one side is hard to latch it means the stud is adjusted too short; note which side it is and proceed with step 1If the box is too loose or too tight proceed with step 2Otherwise, leave the vehicle as is1Check if there is lot of slack in the box latch by lifting one side at time while the mechanism is still closedDo not force itIf it is very loose, note how much it travels2Open the rear cargo box and remove the rubber cap no74 on the studs by pulling them downwards3Use 13 mm key to tighten or untighten the studs on each side depending on the adjustment neededNote that the space between the large washer no75 and the box frame should remain between 11 mm (.433 in) and 19 mm (.748 in)4Install the rubber cap and close the boxRepeat the procedure until the box is well adjusted and until it locks on each side whenever it is closed